The two-way switch front and the back view is shown in the below figure. This is the function of two way switch wiring. Similarly, the light is ON when the first switch COM terminal is connected with the L 2 terminal and the second switch COM terminal is connected with the L 1 terminal. The light is ON when the first switch COM terminal is connected with the L 1 terminal and the second switch COM terminal is connected with the L 2 terminal.
If both MS1 and MS2 turned ON then the circuit function as Master ON.The light is OFF when COM terminals of both the switches are connected with L 1 or L2 terminals. The switches work in individual control even if the MS2 is turned OFF and kept MS1 ON, but the switch positions to ON/OFF will be just reversed. Because in this condition only one throw makes contact to phase line other makes an open contact to the common pole. In normal time, MS1 left open and MS2 needs to turned ON to operate the switches individually. Now turning OFF the MS1 and MS2 will completely isolate the SPDT switches from all phase lines, and this state act as master off state. Now we can control both the phase lines connected to the two terminals of the SPDT switches using master switches MS1 and MS2. This circuit is the same as the master ON circuit the only change is an additional Master switch (MS2) which is added to the phase line that was previously connected directly to the terminals of switches S1 to S4. This wiring arrangement can turn ON or OFF lamps irrespective of their individual switch positions. Here circuit has the combined functionality of master ON switch and Master OFF switch wiring. Because only one throw is required in this circuit. SPDT switches are not required if only needs master OFF function, an SPST switch is enough for that.
Then whatever the switch position is no phase line will reach the individual switches. If the Phase line from the MCB is not arranged for a specific group of loads or a switch position for easy access is required, then simply add a switch to the phase line that can isolate the supply to the loads. In most of the wiring, the Master OFF feature can be achieved by just turning OFF the MCB of the respective loads. For that functionality, a master OFF switch circuit is used.
Hence, in either ON or OFF position of the SPDT switch the common pole has contact to the phase line and the lamp remains ON.Ī master ON circuit arrangement can turn ON lamps irrespective of individual position, but this circuit cannot prevent a lamp from turning ON and keep a circuit OFF. So, the switch S1, S2, S3, and S4 can individually control lamps L1, L2, 元, and L4 respectively.Ĭonsider the Master switch is ON, at this condition both the terminals of the SPDT switches have phase line. So only switches positioned to the live terminal (connected to direct phase line) will ON the lamp, where switches positioned to open terminal OFF the lamp.
So, one terminal of the SPDT switch will always have a phase line and the other terminals will have a phase line only if the master switch is turned ON.Ĭonsider the master switch is OFF (MS1 – OFF), in this condition only one terminal of the SPDT switches has the phase line, and all the terminals connected to the master switch remain open. The common pole of each SPDT switches S1 to S4 are connected to the respective lamps L1 to L4, also the neutral line is distributed parallel to each lamp.ġ st terminal of each SPDT switch S1 to S4 is connected to the Phase line (L) and the other to the phase line through the Master switch (MS1). In the circuit, the Master switch (MS1) is an SPST switch and S1, S2, S3, S4 are SPDT switches.